Delivery and installation

To prevent any delay in delivery and installation, we would like to ask you to organize and check a number of things at your location. Our mechanic needs the following to successfully complete an installation and training.

Requirements upon delivery:
- Is a fork-lift truck with long forks or a dock shelter available? 
- For a Q-range tray forming machine, a forklift with a lifting capacity of at least 2.5 tons must be present.
- For a FP-4/2M tray forming machine, a forklift truck with a lifting capacity of at least 3.5 tons must be present.
- See below the instructional videos for loading and unloading a Boix machine:

Unloading/loading with a forklift:                                            Unloading via a loading and unloading dock:

 

Requirements for the installation:
- Electrical current 400V 5-pins (3F + N + A / 50Hz).
- Boix provides a 32A/5-pin plug, Neoprene cable and air hose 13 mm.
- Hotmelt glue.
- Sufficient production blanks, at least 1.500 blanks.
- During installation there must be an operator or other employee present at all times.


Additional requirements if the machine is delivered without a compressor:
- Compressed air 7 Bar with a capacity of approximately 700 L / min for Q-range tray forming machines.
- Compressed air 7 Bar with a capacity of approximately 1,000 L / min for FP-4/2M tray forming machines.
- The 7 bar compressed air pressure is only applicable to the tray forming machine, not in combination with a stacker.
- The customer is responsible for providing an air nipple for connecting the air supply to the airhose. 

Your Box Forming Partner